Reply to thread

Message: <blockquote data-quote="CYKSxx7" data-source="post: 216086" data-attributes="member: 3613"><p>Sirs, This is the First time I'm in this Bike (86 CR250R) it was a Gift too me as a Project. I know it should be that simple to remove the Lifter Rod (Pushrod) Lock Washer, Locknut, Disc's and Pressure Plates. I've done it before a Few Times on Bikes I have had in the Past. I also know better than to use Thread locker on Bolts no larger than M8 x 135 x 1.25 x with a Low Grade Bolt or nut. Then over Torque them. You get the Idea. I never use the stuff. I'm trying to get the Pushrod Out, now I'm going crazy trying to remove the Clutch (with Heat) to get at the Rod which should come right out. I'll try to get my hands on a 1/2" Air Impact wrench. If that fails, what type service would Torch it for me ? An Auto Repair Shop, Machinist ?</p></blockquote><p></p>