Reply to thread

Message

Sir, Yes you were correct, I'm disassembling the Clutch Pressure Plate, Center Plate and Possibly the Outer Housing, to get access to the Lifter Rod (a.k.a. Pushrod) which will not come out of the Main Shaft (I believe it's the First Gear Shaft). After I remove the Clutch assembly (which should be that simple) the Lifter Rod (Pushrod) should be in plain site. Or enough room to grasp it and see why it's not coming out of the Shaft. BUT Now I can't Remove the LOCKNUT, the person whom had the Bike before me Cranked the NUT On. Thank you Sir's your advice means a lot too me.

[QUOTE="CYKSxx7, post: 216104, member: 3613"] Sir, Yes you were correct, I'm disassembling the Clutch Pressure Plate, Center Plate and Possibly the Outer Housing, to get access to the Lifter Rod (a.k.a. Pushrod) which will not come out of the Main Shaft (I believe it's the First Gear Shaft). After I remove the Clutch assembly (which should be that simple) the Lifter Rod (Pushrod) should be in plain site. Or enough room to grasp it and see why it's not coming out of the Shaft. BUT Now I can't Remove the LOCKNUT, the person whom had the Bike before me Cranked the NUT On. Thank you Sir's your advice means a lot too me. [/QUOTE]

Verification