Reply to thread

Message

<blockquote data-quote="2smoke" data-source="post: 149698" data-attributes="member: 563">This is what FMF recommends for you year make model, from sea level to 1500 ft in elevation.<ul>
<li data-xf-list-type="ul">Main Jet</li>
<li data-xf-list-type="ul">390</li>
</ul>
<ul>
<li data-xf-list-type="ul">Pilot Jet</li>
<li data-xf-list-type="ul">42.5</li>
</ul>
<ul>
<li data-xf-list-type="ul">Needle</li>
<li data-xf-list-type="ul">STOCK</li>
</ul>
<ul>
<li data-xf-list-type="ul">Needle Position</li>
<li data-xf-list-type="ul">3RD</li>
</ul>
<ul>
<li data-xf-list-type="ul">Power Jet</li>
<li data-xf-list-type="ul">N/A</li>
</ul>
<ul>
<li data-xf-list-type="ul">Air Screw</li>
<li data-xf-list-type="ul">1.5</li>
</ul>
<ul>
<li data-xf-list-type="ul">Fuel Screw</li>
<li data-xf-list-type="ul">N/A</li>
</ul>But I did notice that you are running the big bore kit. So these values and adjustments might be off just a little.How long had the bike sat for before you ran it last? = sour fuelWas the fuel fresh? = The fuel in the gas tank will sour in a months time and make it run crappyWas it hard to start? = Could be your reed valves.You stated that the took apart the carb. and everything looked OK.= But did you actually clean it?&nbsp; Spray carb cleaner in all the passage ways air and fuel specific.</blockquote>

[QUOTE="2smoke, post: 149698, member: 563"] This is what FMF recommends for you year make model, from sea level to 1500 ft in elevation. [LIST] [*]Main Jet [*]390 [/LIST] [LIST] [*]Pilot Jet [*]42.5 [/LIST] [LIST] [*]Needle [*]STOCK [/LIST] [LIST] [*]Needle Position [*]3RD [/LIST] [LIST] [*]Power Jet [*]N/A [/LIST] [LIST] [*]Air Screw [*]1.5 [/LIST] [LIST] [*]Fuel Screw [*]N/A [/LIST] But I did notice that you are running the big bore kit. So these values and adjustments might be off just a little. How long had the bike sat for before you ran it last? = sour fuel Was the fuel fresh? = The fuel in the gas tank will sour in a months time and make it run crappy Was it hard to start? = Could be your reed valves. You stated that the took apart the carb. and everything looked OK.= But did you actually clean it? Spray carb cleaner in all the passage ways air and fuel specific. [/QUOTE]

Verification